Automatic
door operator shall be electromechanical, and
provide for both powered opening and powered closing
of a door. The door opener shall provide no influence
upon the door except when it is actively involved
with powered opening, holding open, or closing,
thus allowing unencumbered manual operation.
The unit shall contain aninternal battery power
supply to provide powered operation in the event
of external power failure. The unit shall be powered
by 24 vac, external to the device under provisions
of low voltage wiring and is supplied with a 40
VA transformer requiring 115 vac 60 Hz service.
The operator shall be mounted according to drawings
and nstructions provided with each unit. The unit
shall be capable of mounting on either door or
lintel and shall provide door opening angles up
to 180 degrees.
The unit shall possess an adjustable hold-open
feature allowing the door between 5 and 60 seconds
for passage. The unit shall stop when encountering
an obstruction during an operating cycle at which
time it ceases to provide an influence on the
door.
Operation
Electro-mechanical. Power open, power close.
Automatic clutch disengagement at all times when
not activated, allowing unimpeded manual operation.
|
Automatic open-hold-close cycle (5 to 60 seconds)
activated by a signal from internal radio receiver
or the momentary closure of electrical contacts
provided by wires to unit.
Automatic cycle may be interrupted by a signal
received within the cycle bringing the operator
into a disengaged state. Door may be closed remotely
if door is found left open in a non-active state
upon receipt of a signal.
Optional Mode (Auto-Close setting) - Causes door
to close automatically after a delay upon manual
opening. Can be brought into activation in one
of three ways:
1. Provision of electrical wires to unit to provide
a discontinuity between internal contacts.
2. Provision of discontinuity of contacts upon
installation.
3. Removal of 24 vac external power to operator.
Electrical
Specifications
Operator:
16-24 vac/dc
Wall Transformer:
Input - 115 vac, 60 Hz
Output - 24 vac, 10VA
Battery:
12V DC, 1.2Ah lead acid gel cell
Motor:
12V DC, 1.5A
Clutch:
12V DC, 0.5A
|
Supply
for Unlatching Device:
12V DC, 1A
Radio Receiver:
19,683 Security Combinations (Programmable)
Dimensions:
2 5/8” x 4" x 14 1/8” (Suitable
for mounting with perpendicular wall close to
door frame.)
Weight:
10 Lbs.
Material/Finish:
Steel housing
Powder coated finish
Physical Applications:
Door mounted for inward and outward opening
doors in either right-hand or left-hand hinged
configurations. (Ceiling clearance 1 1/4”
minimum between dooe and ceiling). Lintel mounted
for inward and outward opening doors in either
right-hand or left-hand hinged configurations.
Activation
Activation may
occur by coded signal from transmitter or by wireless
security entry system. Activation contacts are
provided within unit for remote wired activation
from any device providing momentary continuity
such as touchplates, pushplates, mats, or infrared
motion sensors.
________________________
Warranty
Open Sesame Operators
and controls are covered by a one year limmited
warranty on materials and internal workmanship.
Our warranty does not apply to services performed
during installation but technical assistance is
available by calling 1-800-OPEN-911.
________________________
|
